Our range of tiny modules are designed to make it easy for you to quickly add functionality to your projects. [Module List
- Joined:Fri Oct 20, 2017 11:07 am
Watchdog Timer Module pulled HIGH or LOW ?
Hi i have a question about watchdog timer module
On the QuickStart page you can read :
The input (IN) connection on the Watchdog Timer Module must be briefly pulled HIGH in order to reset the timer. You can add a simple function to your Arduino sketch which does this for you:
Ok , i understand that the INPUT pin need a pulse to reset the timer
But if for some reason the Arduino get stuck when the pin is HIGH , will the watchdog start the timer , or will it get stuck in a "RESET TIMER" state ?
- Joined:Thu Mar 29, 2018 10:18 pm
This has been a concern of mine as well and the only good solution I can think of is two watchdog circuits triggered by one pin. One would use an inverter before the timer so that when one sees a high pulse, the other sees a low one. No way for both to get stuck. However, then you have to figure out how to feed them both back into the one kill/reset output back to the MCU.