I am trying to upload a sketch to a Pro Mini clone from ebay using the Freetronics USB to serial adapter and the Arduino IDE, but I can not get it to work. The sketch compiles and it says "Uploading" but there is no is no activity on the rx/tx leds and after a while I get the error "Programmer is not responding". I have Connecting the adapter to the Pro Mini's ftdi header pins and I have tried using wire vout/gnd/rx/tx -> vcc/gnd/rx/tx. I have also tried rx/tx -> tx/rx, but the result is the same.
Using a "naked" UNO (removed the micro controller) as a Usb-serial adapter works fine.
Any ideas to what I have to do to be able to use the adapter?
Our range of tiny modules are designed to make it easy for you to quickly add functionality to your projects. [Module List]
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests