Search found 3 matches

by charlesjudd
Tue May 09, 2017 1:41 am
Forum: EtherTen
Topic: Ether10 and Relay8 shields
Replies: 1
Views: 2560

Re: Ether10 and Relay8 shields

It appears that EtherTen has a unique configuration when compared with an Arduino Uno. When any of the i2C/PullUp resistors are cut on Relay8 board and/or EtherTen, no power is supplied from EtherTen to the Relay8 shield. This differs to the Arduino Uno which appears to provide power to the Relay8 s...
by charlesjudd
Tue May 02, 2017 8:41 am
Forum: EtherTen
Topic: Ether10 and Relay8 shields
Replies: 1
Views: 2560

Ether10 and Relay8 shields

Hello, I have 2 x Relay8 shields. I have this working 100% on an Arduino Uno board. In serial monitor; Press A to select Relay8 shieldA (0x20) Then press 1-8 to toggle relay on/off. Press B to select Relay8 shieldB (0x21) Then press 1-8 to toggle relay on/off Both Relay8 shields have been configured...
by charlesjudd
Tue May 02, 2017 8:33 am
Forum: EtherTen
Topic: EtherTen and Relay 8 Shields
Replies: 8
Views: 6667

Re: EtherTen and Relay 8 Shields

Hi What version of EtherTen are you using please? I can get two Relay8 shields working ok on an arduino uno, but cannot get it working on a Rev3 Etherten. Did you need to disable the etherten i2c pull-up resistor to allow the i2c communication to work correctly? Any other advice issues you faced wit...