Search found 177 matches
- Sun Sep 29, 2019 2:14 am
- Forum: Random Chit-Chat
- Topic: Setting up a new ATmena328P
- Replies: 0
- Views: 288
If you obtain a new ATmega328P it will not generally work in an Arduino or programme via a programmer such as the USBasp using the Arduino environment without some pre-configuration. Not all the default settings in a new device are what is used in a Uno. This is an attempt to explain what needs to b...
- Thu Sep 26, 2019 10:39 pm
- Forum: Dot Matrix Display
- Topic: how do you scroll text from far right to left by pixel column properly?
- Replies: 2
- Views: 289
I suspect this is a problem with the DMD2 library. It does not handle scrolling text (marquee) very well with multiple DMDs. You might have greater success with the DMD library. It will not be difficult to give it a try and see how you go. But you need to be aware that each DMD takes time to update ...
You do not provide enough details to allow people to offer much help. - no idea what PoE board you are using - no idea of what is actually getting hot - no idea of how you have them set up - does the problem stay with the PoE board if you swap them over? - have you double-checked all your wiring? - ...
- Thu Sep 19, 2019 11:14 pm
- Forum: EtherTen
- Topic: I want to share an interesting information for you
- Replies: 1
- Views: 131
You did not state which Arduino, so I will assume a Uno. The on-board regulator has maximum current of 1Amp, so that is the absolute limit. However there are other factors here: - the limit will be reduced by the power required by the on-board circuitry, so about 900mAmps - the regulator will almost...
- Fri Sep 13, 2019 4:53 am
- Forum: RX315/RX433: 315MHz and 433MHz Receiver Shields
- Topic: Can the RX433 shield be used to decode Directv RC 73 remote
- Replies: 1
- Views: 395
Haven't heard of anyone doing this. I think you would have to do your own decoding which may be a challenge. Maybe if you could get hold of the receiver/decoder from an old set it might make your task easier. Do they even run at the same frequency? The 433mHz band covers a range of frequencies. Also...
Just thought I might throw this up here just in case it might help someone. This is an example of software debouncing using vertical counters as described here. I have adapted it to suit my own needs and again here to demonstrate a possible way it could be used in the Arduino environment, but the co...
I really like this routine for debouncing. It is quick and very efficient, and it really does work. You will need to modify it to suit your monitored inputs. I have used modified versions of this one several times using Timer1 at around 5 to 10 milliSeconds Timer1.initialize( 10000 ); // 10000uS = 1...
From a quick look, you need to re-think how you are reading and 'debouncing' the buttons. There are lots of resources available to give you some information on debouncing. You would be much better off doing the read & debounce task in a timed interrupt.